Aqua Lung Calypso Instrukcja Naprawy

Authorized TechnicianTECHNICAL MAINTENANCE MANUALCALYPSO/TITAN/OCTOPUS SECOND STAGE

10 Lever Height Adjustment17. Pressurize the regulator18. Slide the notch of the ad-justing tool 125727 across the top of the box bottom (4) The

Calypso/Titan Second Stage Service Manual 11 NOTE: If your facility is equipped with a test bench, perform the tests before installing the mouthpiec

12 2. Observe any bubbles arising from the sub-merged regulator over a one minute period. The recommended time is necessary due to slower bubble f

Calypso/Titan Second Stage Service Manual 13Table 1 - Troubleshooting GuideSYMPTOM POSSIBLE CAUSE TREATMENTLeak or freefl ow at 2nd Stage1. MP too h

14 Table 2 - Recommended Tool ListPART NO. DESCRIPTION APPLICATION111610 I.P. test gauge Intermediate pressure testing944022 O-ring tools O-ring rem

Calypso/Titan Second Stage Service Manual 15Table 4 - Recommended Lubricants & CleanersLUBRICANT / CLEANER APPLICATION SOURCEChristo-Lube® MCG-1

16 Procedure ACleaning & LubricationAqua Lung and Apeks Regulators and NitroxWhen it comes to issues of nitrox safety and compatibility, the con

Calypso/Titan Second Stage Service Manual 17Table 6 - Test Bench Specifi cationsTEST CONDITION ACCEPTABLE RANGELeak Test Inlet 2,500-3,000 (±100) psi

18 NOTES

Calypso/Titan Second Stage Service Manual 19Titan • Calypso • Octopus (2004 - present)Exploded Parts Diagram Key # Part # Description n/a ---

2 ContentsCOPYRIGHT NOTICE...

Authorized TechnicianTECHNICAL MAINTENANCE MANUALCALYPSO/TITAN/OCTOPUS SECOND STAGEAqua Lung America2340 Cousteau Court, Vista CA 92081Tel: 760-597-

Calypso/Titan Second Stage Service Manual 3COPYRIGHT NOTICEThis manual is copyrighted, all rights reserved. It may not, in whole or in part, be copi

4 GENERAL CONVENTIONSUnless otherwise instructed, the following terminology and tech-niques are assumed:1. When instructed to remove, unscrew, or l

Calypso/Titan Second Stage Service Manual 54. While holding the second stage secure, fi rmly grasp the collar of the front cover (1) which is seate

6 NOTE: Because the crown is o-ring sealed, it will not freely exit the valve body after it has been disengaged. The following step must be perf

Calypso/Titan Second Stage Service Manual 720. Place the handle of the extraction tool directly over the poppet bearing (20) in the top center of t

8 4. Using tool p/n 125727, engage the slotted head of the crown (14) and drive it in clockwise as far as the tool will allow. If the tool is not a

Calypso/Titan Second Stage Service Manual 911. Place the washer (17) over the poppet shaft (22), followed by the locknut (16), with the fl at side f