Aqua Lung Kronos Instrukcja Obsługi Pobierz pdf (Strona 11)

FIRST TO DIVE 11

FINAL ASSEMBLY (cf VE 103191)

1. With the regulator under pressure, insert the piston

(127581) into the dry chamber. Place the diaphragm

(127579) right to the bottom of the diaphragm screw

(127582). Screw it fully home on the body using a lug

spanner (129198)

2. Check that the MP is still stable (see table 5)

3. Close the cylinder valve and purge the regulator.

Remove the pressure gauge and replace the MP plug.

END OF REASSEMBLY

TEST IN WATER

Check that all the MP and HP plugs are in place and that a

correctly adjusted second stage is connected to the first

stage. Slowly open the cylinder valve to put the regulator

under pressure.

Immerse the first stage completely in water to check that

there are no leaks.

When you are sure that there is no leak, close the cylinder

valve and purge the regulator. Remove the first stage from

the cylinder and refit the dust cap.

If a leak has been detected then note its source and refer to

Table 1. Troubleshooting Guide.

Note: The following step should be carried

out with the regulator under pressure.

Note: Do not mistake any bubbles that are

trapped in the regulator with a leak. If there

is a leak there will be a constant stream of

bubbles.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Brak uwag

Aqua Lung Kronos Instrukcja Obsługi Strona 11