Aqua Lung Kronos Instrukcja Obsługi Pobierz pdf (Strona 7)

FIRST TO DIVE 7

17. Remove the body from the vice, turn it over, and recover

the seat (127585) using the seat tool (116236). Remove

the seat seal (124704)

18. Remove the MP (122233) and HP (122237) plugs.

Remove their O-rings (124703) et (124701).

END OF DISASSEMBLY

Before starting to re-assemble the regulator,

make sure that all replacement parts have

been cleaned and lubricated in accordance

with Procedure A : Cleaning and Lubricating

on page 14

RE-ASSEMBLY PROCEDURE

Fit a new lubricated O-ring (124704) on the seat (127585).

Slide the seat onto the tool (116236), push the seat into the

body (HP side) to position the seat and push with the tool.

1. Screw the holding tool (116320) into a port and grip the

body in a vice. Fit the valve (124624) (with its face

toward the inside of the body) and fir the spring

(122244).

2. Fit a new lubricated anti-extrusion washer (119129) then

a new lubricated O-ring (124612) in the spring block

(127562). Using a small brush add a little grease to the

inside of the spring block.

Note: Before continuing, closely examine the anti-

extrusion washer (119129). You will note that it

has a flat side and a concave side. For correct

assembly the concave side should be against the

O-ring, as shown in the picture below.

O-ring

nti extrusion washer

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Brak uwag

Aqua Lung Kronos Instrukcja Obsługi Strona 7